Featured
How To Adjust Paintball Regulator Output Pressure
How To Adjust Paintball Regulator Output Pressure. I would do the following: In paintball, carbon dioxide (co2) has two different forms.
So you’d need a tank that outputs at least 250psi to prevent the gun from starving for air and causing shoot down. “the emf100/emek 100 says output pressure: Once you start cranking down on the ‘adjuster’, the spring pressure on the ‘reg piston’ gradually forces the ‘seat’ open, allowing the ‘supply’ pressure to flow to the ‘output’ side.
The First Is A Condensed Liquid That Is In Your Paintball Tanks.
A regulator can be one of the best additions to a paintball gun. Single stage regulators used to give up precision and reliability (compared to dual stage regulators), but that is not necessarily the case anymore. How to adjust paintball regulator output pressure.
The Standard Adjustable Ships At 800Psi And Allows You To Adjust Your Pressure From 500Psi, 650Psi, Or 800Psi.
Up the output pressure again and repeat this process. The ideal output pressure for your tank regulator is between 300psi and 500psi (depending on fire rate). Then, again, gradually increase the pressure to the desired set point.
The Emek Runs At 135 Psi.
That displays the pressure in the tank. So you’d need a tank that outputs at least 250psi to prevent the gun from starving for air and causing shoot down. Let's say the ratio is 50:1, that means for every drop in 50psi input, the output increases by 1psi.
Use The Output Connection On The Asa To Connect The Lines That Will Carry The Air To A Regulator.
Recommended output pressure for hp systems. Once you start cranking down on the ‘adjuster’, the spring pressure on the ‘reg piston’ gradually forces the ‘seat’ open, allowing the ‘supply’ pressure to flow to the ‘output’ side. If your marker operates on 250 psi and you have your tank output set to 500 psi the 250 psi regulator will have to stay open longer to refill the 250 psi area in the marker before the valve than if the output on the tank regulator was 800 psi.
250 > 450 That’s The Recommend Pressure From Pe.
The condensed co2 in liquid form expands into the usable gas form. This regulator is our least expensive regulator available while still giving you the ability to adjust your output pressure to whatever marker you decide to shoot. A standard air compressor regulator will be able to lower the psi to 100 and can be found at your local home depot/lowes.
Comments
Post a Comment